Command              Description

----------------------------------------------------------------

AT                   Check if the command terminal work normally

AT+RESET             Software reboot

AT+VERSION           Get firmware, bluetooth, HCI and LMP version

AT+HELP              List all the commands

AT+NAME              Get/Set local device name

AT+PIN               Get/Set pin code for pairing

AT+BAUD              Get/Set baud rate

AT+CLEAR             Remove the remembered remote address

AT+LADDR             Get local bluetooth address

AT+DEFAULT           Restore factory default

AT+COD               Get/Set local class of device

AT+IAC               Get/Set inquiry access code

AT+ROLE              Get/Set master or slave mode

AT+STATE             Get current state

AT+UARTMODE          Get/Set uart stop bits and parity

AT+ENABLEIND         Enable/Disable Indication print

AT+LSP               List Paired Device List

AT+RESETPDL          Reset Paired Device List
AT+REMOVEPDL         Remove one entry from Paired Device List

-----------------------------------------------------------------

Note: (M) = The command support master mode only, other commands

support both master and slave mode.

For more information, please visit http://www.bolutek.cn

Copyright@2012 www.bolutek.cn. All rights reserved.